Thread subject: Diptera.info :: Posting drawings as pdf files

Posted by Michael Ackland on 05-05-2008 09:40
#1

I want to find out how to post pdf drawings to the forum, which can be opened in Acrobat by clicking on the link.

So I attach some drawings of Lasiomma anthomyinum Rond to find out what happens

Posted by Michael Ackland on 05-05-2008 09:42
#2

That did not work! Try again

Posted by Michael Ackland on 05-05-2008 09:48
#3

I have altered the name of the file

Posted by Michael Ackland on 05-05-2008 09:52
#4

Success! I made a copy of the file, and cut out the spaces. Ant comments?

Posted by Gordon on 05-05-2008 10:49
#5

Dear Mike,
I was able to access the file simply by double clicking on it so I guess everybody can as well. Would you have a drawing of an Anthomyiid wing, I am trying to learn to separate scathophagids on the basis of wing venation. Jan Maca tried to help when he was here, but I didn't write anything down and now I forget which was which, on anal vein reaching the wing margin or not reaching it. On the flies I am comparing there are 3 veins not touched by the costa, numbering 1, 2, and 3 from the wing tip to the anal lobe. 1 and 2 are straight 3 is usually curved to some extent). No. 1 always reaches or gets very close to the wing margin and sometimes seems to project deyond it as a small spine. In some 2 fades out in the second half, but can be seen to reach the margin, in others it is much fainter, or apparently absent. As far as I can see 3 never reaches the margin, but it does get closer in some than others.

Any other tips on separating the two groups, linked in my mind by the absence of serious bends in the major veins, and bare or basically bare antennae will be greatfully received.

Hoping you, or somebody else, can help me make sense of this.:)

Thanks,

Gordon


Posted by Michael Ackland on 05-05-2008 15:32
#6

I will come back to you on this, Gordon. I shall be seeing Adrian Pont this week in Oxford, taking your Kirkini material. So it may be the end of the week.

Posted by Tony T on 05-05-2008 16:22
#7

Michael Ackland wrote:
Success! I made a copy of the file, and cut out the spaces. Ant comments?


Drawings are very clear. Could get rid of a lot of white space around top and sides. Also, indication of orientation and labelling the various parts would be useful.

Posted by Michael Ackland on 05-05-2008 17:55
#8

Labelling can be easily done in future. I was just concerned with getting the file name to appear. As the drawings do not appear in the thread, and the PDF files are very small, it seems unnecessary to spend extra time in trimming them.

Posted by Tony T on 05-05-2008 18:38
#9

Michael Ackland wrote:
Success! I made a copy of the file, and cut out the spaces. Ant comments?


My mistake. What sort of comments were you expecting?:(